Shop Luxaire Parts

Furnace control board. The control board regulates the supply of power to the furnace components.

Furnace hot surface igniter kit. The igniter gets very hot and glows bright orange to light the gas burner. If the igniter is cracked or defective, the furnace won’t heat.

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

Flame sensor

Genteq Run Capacitor 370 Volt Oval Single 7.5 MFD

Gas Burner Tube

Condenser fan motor 1/4hp 230v 850rpm 1ph

Flame rollout limit switch, push button to re-set

Contactor with shunt, 1 pole, 30 amps, 24 volts

Triple-D Coil Cleaner is a 19oz Aerosol spray can, that is safe for homeowner use. One can will clean an entire outdoor condenser coil and/or indoor evaporator coil, to remove energy-stealing dirt, debris and soot.

Limit thermostat, 150 open, 110 close

Blade fuse. ATC-3 (3 Amp)

Dual Capacitor 45 + 5 MFD 370 volt

Run capacitor, single,10mfd,370 volts, oval

2.8 oz Tube of Red Devil High Temp RTV Silicone. Perfect for Gasket replacement. Not for Heat Exchangers.