Shop ICP Parts

Furnace draft inducer assembly. The draft inducer motor draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.

Flame rollout switch 300F resetable

Furnace draft inducer motor. The draft inducer motor draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.

Sensor flame

Control fan timer

Blower vent 80+ 1-stg jakel kt

Hot surface furnace igniter kit.
If the electrical connnector on your old part is different than the new igniter, it can be cut off and spliced onto the new igniter wires using the provided wire nuts.

Triple-D Coil Cleaner is a 19oz Aerosol spray can, that is safe for homeowner use. One can will clean an entire outdoor condenser coil and/or indoor evaporator coil, to remove energy-stealing dirt, debris and soot.

Contactor 1 pole 25 amp 24 volt

Condenser fan motor. This single-phase motor has the following specifications:

Horsepower: 1/5
Voltage: 208-230
Full-Load Amperage: 1.3
Hertz: 60
RPM: 1075
Rotation: counterclockwise
Frame: 48
Enclosure: Closed
Shaft Length: 2.5”

Control furnace 1-stg

Furnace burner igniter and flame sensor assembly. This is a 24 volt igniter.

3 Blade fan, 18" diameter 28 degree 1/2" CW

1/6 HP 208/230Volts 60Hertz 0.99Amps 1100RPM Single Speed Closed Enclosure 42Y Frame Single Phase Reversible Rotation 1.75" Shaft

Hot surface igniter