OEM LG Parts for Appliances

Microwave incandescent light bulb, 40 Watt. Has small screw in base. If the light bulb threads are corroded, or the bulb base is too large, the socket may also need to be replaced.

Washing machine drain pump. If the washer does not drain then the drain pump may be clogged, damaged, or defective.

Set of two drum rollers. Includes the roller shaft and mounting clips.As the bearing in the roller wears, it self-lubricates so no grease is needed. If the dryer is noisy then one or more of the rollers may be worn. The rollers should be replaced in sets either both front or both rear.

Washer hot water inlet valve. Standard hose fitting inlet, 1 water outlet. The water inlet valve opens to allow water to enter the washing machine. If the water inlet valve is defective, the wash may fill slowly or not fill at all.

Grease Filter. Measures approximately 7-3/4" X 5"

Washer cold water inlet valve assembly. Three solenoids. Hot water valve is a separate single coil valve and can be found in related parts

Dryer lint filter. Some models have a updated housing. If you need a filter without the notches on top please see related item #4960837.

Dryer drum drive belt. 1/4 inch wide with 4 ribs and 3 grooves. The drive belt is a very long, slender belt that wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.

Holder

Washing machine door boot gasket with drain port. If the door boot is torn, the washer will leak water. The most common cause of a torn door boot is if the washer is overloaded. Be aware that your model may also list a door boot without drain port. Be sure to check the original part before ordering.

Dryer thermal fuse. If the dryer overheats, the thermal fuse blows to cut off power to the dryer. If the thermal fuse has blown, the dryer won't start. The thermal fuse cannot be reset—if the fuse has blown, replace it. Thermal fuses often blow due to a clogged vent.

Dishwasher hinge cable. This cable connects the door hinge to the door spring.

Washing machine rotor position sensor assembly. This part is also called a hall sensor or motor sensor. When this part fails the control may display an LE error code.

Washing machine pulsator assembly (or wash plate) with screw.

Thermostat and thermistor kit. The thermostat has reset button in center it is trips due to poor air flow such as a clogged exhaust vent.