OEM GE Appliance Parts

Set of two drum rollers. Includes the roller shaft and mounting clips.As the bearing in the roller wears, it self-lubricates so no grease is needed. If the dryer is noisy then one or more of the rollers may be worn. The rollers should be replaced in sets either both front or both rear.

40 Watt frosted appliance light bulb.

Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.

Dryer drum drive belt, 89-1/2 inches long, 4 ribs. The drive belt is a very long, slender belt that wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.

Dishwasher door gasket (or door seal). This door gasket creates a seal around the dishwasher to prevent water from leaking out. If the gasket is torn, the dishwasher will leak water.

Dryer drum slide. There are two of these needed on your dryer. These go on the inner most slots on the front bearing. Sold individually will need to purchase two*. The drum slides support the front of the dryer drum instead of rollers or bearings. As they wear out the dryer will make more noise.

Dryer drum slide. There are two of these needed on your dryer. The dryer's drum slides help to support the front of the drum as it rotates. If the drum slides are worn out, the dryer will be noisy. Because the slides wear out at the same rate, we recommend replacing all of the slides together.

Washer drive motor coupler. New style with metal sleeves for added strength. This version replaces all previous motor coupler styles and versions. For direct drive washing machines. Common symptom of failed coupler is washer will fill, not agitate or spin but will drain the water from the tub.

Bottom tank gasket

Lower spray arm

Oven igniter assembly. Short ceramic style igniter with mounting bracket and wire nuts for installation. Amperage range is 3.3 to 3.6. *Connector may need to be cut off and wires spliced to range wiring with porcelain wire nuts.

Dishwasher door latch assembly

Lint Filter with Frame

Dryer drum slide, gray

Orbital sprayer, blue