Shop Payne Parts

Flame sensor

Furnace draft inducer mounting grommet. This grommet helps isolate the blower assembly from the furnace to reduce noise.

Dual Capacitor, 45+ 5 MFD, 440 volts

Flame rollout limit switch, re-settable. opens at 250f

Nitride Hot Surface Furnace Ignitor

Flame rollout limit switch re-settable 350F

Gas burner tube

Inducer motor assembly. This assembly is designed for 40, 60, 80, and 100 thousand BTU model furnaces. Your furnace's BTU rating may be listed on the model number tag. You can also determine the rating from your model number—the 3-digit number preceding the hyphen indicates the BTU rating.

Carrier furnace igniter. The igniter gets very hot and glows bright orange to light the gas burner. If the igniter is cracked or defective, the furnace won’t heat.

Screw

Furnace draft inducer motor cooling fan blade and clip. You may have to cut the old clip off to remove the fan blade.

Gasket, draft inducer housing

Furnace draft inducer motor kit. The draft inducer motor draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.

Dual run capacitor round 440 V 35/5 uF

Furnace draft inducer motor with cooling fan. Be aware that the screw holes are not threaded—you will need to use self-tapping screws to install the motor.