LG Dryer Parts

Set of two drum rollers. Includes the roller shaft and mounting clips.As the bearing in the roller wears, it self-lubricates so no grease is needed. If the dryer is noisy then one or more of the rollers may be worn. The rollers should be replaced in sets either both front or both rear.

Dryer lint filter. Some models have a updated housing. If you need a filter without the notches on top please see related item #4960837.

Dryer drum drive belt. 1/4 inch wide with 4 ribs and 3 grooves. The drive belt is a very long, slender belt that wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.

Dryer thermal fuse. If the dryer overheats, the thermal fuse blows to cut off power to the dryer. If the thermal fuse has blown, the dryer won't start. The thermal fuse cannot be reset—if the fuse has blown, replace it. Thermal fuses often blow due to a clogged vent.

Thermostat and thermistor kit. The thermostat has reset button in center it is trips due to poor air flow such as a clogged exhaust vent.

25 watt light-bulb for various appliances, 130 volts, small base screw-in. Bulb has been updated and you may need the recommended socket to install this light bulb. Also bulb is no longer blue tint per factory.

Lint filter cover *manufacture has modified the part and suggests replacing the filter guide and filter also. Old filter may not fit updated part. See below.

Dryer lint filter assembly with felt rim seal attached. Proper air flow is critical to dryer operation so the filter should be cleaned before every load. Replace the filter if it has any tears or rips in it.

Guide cover

Dryer moisture sensor bar. If the dryer timer does not advance properly inspect the moisture sensor bars for damage which can cause the automatic drying cycle to not work properly.

High limit thermostat at blower housing

Dryer lint filter assembly with felt rim seal attached. Proper air flow is critical to dryer operation so the filter should be cleaned before every load. Replace the filter if it has any tears or rips in it.

Dryer idler pulley and spring kit for drum drive belt

LP conversion kit *Note: Sticker indicating the gas type is not included.

Dryer heating element assembly. If the dryer no longer heats then the heating element may have failed, but it is not the most common cause. The most common cause for a dryer to stop heating is a blown thermal fuse.