Shop Hotpoint Stove & Oven Parts

40 Watt frosted appliance light bulb.

Oven igniter assembly. Short ceramic style igniter with mounting bracket and wire nuts for installation. Amperage range is 3.3 to 3.6. *Connector may need to be cut off and wires spliced to range wiring with porcelain wire nuts.

Light bulb 40 watt 120 volt medium standard base. Used in many refrigerators and ranges.

Oven bake heating element. Push-on wire terminals. Includes feet for sitting on bottom of oven floor, and mounting plate for attaching to back wall of oven. Often, if the heating element has burned out, it will be visibly damaged. Inspect the heating element for holes or blisters.

Oven bake or broil igniter, 2.5 to 3.0 Amp. The igniter draws electrical current through the oven safety valve to open it. If the igniter glows for more than 90 seconds without igniting the gas flame, this indicates that the igniter is too weak to open the valve. (NOTE: This part is very fragile.)

Push to start switch

Burner drip bowl (or drip pan) for 8-inch burner. The drip pan sits underneath the heating element to collect drips or spills around the burner.

Control switch for 2,600 Watt surface element. The surface element switch sends voltage to the surface element coil. If the switch is defective, the surface element will not work.

Oven bake heating element with screw-on terminals. The element is 18-1/4 inches wide, 14-1/2 inches deep to mounting flange. Terminal ends extend 2-1/2 inches past flange. 2,300 watts at 220 volts. If the oven does not heat the bake element may have burned out.

Burner drip bowl (also called a drip pan) for 6-inch burner. The drip pan sits underneath the heating element to collect drips or spills around the burner.

Stove top heating element terminal block kit (receptacle). If the heating element operates intermittently then this terminal block or the elements terminals are likely corroded and both will likely need to be replaced.

Oven sensor

Appliance light bulbs (2 pack).

-40 Watts
*No longer Frosted

Oven bake element. The terminals are male quarter inch spade connectors. The wires push onto the heating elements connectors. If the oven does not bake then the element could have burned out.

Control switch for small surface element. The surface element switch sends voltage to the surface element coil. If the switch is defective, the surface element will not work.