Frigidaire Dryer Parts

Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.

Dryer drum belt, length 88.75" x width 1/4". If the drum does not turn, but you can hear the motor running then there is a good chance the belt has broken.

Dryer rear drum bearing kit. The holes in the metal plate are not threaded. Use the self tapping screws in the kit to thread the plate. If the dryer is noisy then the rear bearing could be worn and require replacement.

White touch-up paint. .6 oz.

Dryer door catch kit. If the dryer does not latch properly then either the strike or catch is likely damaged and will need to be replaced.

Dryer heating element and rear housing assembly. Before checking the heating element, first make sure that the thermal fuse is not defective. Normally, a heating element will have a break in the coil if defective.

Dryer drum drive belt, 5 rib

Appliance light bulbs (2 pack).

-40 Watts
*No longer Frosted

Dryer drum support roller assembly

Front upper felt glide pad. Includes nylon glides, adhesive, and installation instructions. These drum glides help to support the front of the dryer drum as it rotates.

Dryer thermal limiter (or thermal fuse). May be located on the blower housing or element. If the dryer overheats, the thermal fuse blows to cut off power to the dryer. If the thermal fuse has blown, the dryer won't start. The thermal fuse cannot be reset--if the fuse has blown, it must be replaced

Dryer drum glide. These drum glides help to support the front of the dryer drum as it rotates. Sold individually. It is recommended to replace both at one time.

door catch

Front lower felt seal. Comes with high temp adhesive for installation.

Knob for selector switches on washing machines and dryers. Fits onto a D-shaped shaft. Includes shaft spring to hold knob in place.